Plus CP

The CP systems for cutting plastics use a motorized-type cutting head, head working stroke approx. 100 mm, low pressure operation of assisting gas. Low pressure gas management Focal lengths 5''-7.5'', maximum pressure 8 bar, nozzle standoff management.

The CP systems use a self-focusing cutting head with contactless capacitive sensor. The head itself and the focusing lenses can be used up to a pressure of 20 bar. The assisting gas is automatically selected from 3 different connectable gases: air, nitrogen and oxygen whose assisting pressures are determined automatically on the basis of cutting parameters and materials. The head is fitted with an extractable drawer for quick focal changeover. Built-in contactless capacitive sensor, High pressure gas management, Drawer for quick focal changeover, All connections on top, Contact and impact error management, Focal lengths 5”-7.5”, maximum pressure 20 bar, nozzle standoff management.

Galvo head: it is used to carry out logos, codes, etc., on the surface, in such a way as to report identification information of the product being worked.

The suction plate removes exhaust gas emissions exactly when they occur - above and below the kerf.

Compressed air system to prevent accidental flame formation from the cutting of plastics.

CameraVision system (CCD camera) for recognition of positional references (fiducial marks) for automatic position correction (offset and rotation) on the workpiece.

Manual extractable table for loading/unloading the materials to be machined.

This option allows the optimization of machining times, virtually eliminating loading and unloading times. In addition, thick sheets can be loaded without any risk of damage to the main structure.